************************************************************************************ Release Notes for VigorIPPBX 3510 Firmware Version : 3.5.7 (Release Version) VoIP Module : 2.6.6 Release Date : 8th March 2012 Build Date : 10th April 2012 Applicable Models : VigorIPPBX 3510 Series Locale : UK Only ************************************************************************************ IMPORTANT: Please read the known issues and notes before upgrade. [New Features] 1. New comprehensive Auto Attendant mechanism. 2. Support Call queueing mechanism (for hunt group). 3. Support custom trunk (i.e. define an extension for trunk usage) 4. Maximum simultaneous channel usage can be set for each trunk 5. Increased number of SIP trunks from 6 to 12. 6. Increased number of hunt groups from 10 to 20. 7. New 'Random' hunt group ringing mode [Improvement] 1. Resolve interoperability issue with HTC phone. 2. Change Auto Attendant greeting repeat counts from global setting to local menu setting. 3. Shortened the ring-back-timer of queue handler. Change from 40 sec to 20 sec. 4. Support overflow action when queue timeout. 5. Modify the minimum value for timeout for hunt group setting to seconds while in Sequential/Random mode. 6. Improve the function behavior of hunt group voice mail. 7. Improve the greeting behavior of personal voice mail. Users can listen to existing greeting without re-recording it. 8. Ring back tone can be configured as silence. 9. Add ISDN MSN non-office hour answer mode. 10. Support send email via specific WAN function. 11. Add switch for each PSTN port to turn on/off (offnet) play prompt mechanism and integrate with the VoIP module. 12. Add a new Telnet command that 9 countries tone profiles can be set for the tone setting. 13. The user can register from VPN when remote registration is disabled. 14. Fix the error of RTP proxy handling. 15. Fix the error of extension monitor display. 16. Fixed that a user can not leave voice message to hunt group number. 17. VigorIPPBX stores more than 100 voice mails in USB disk. 18. Fixed One-way audio issue with some ITSP. 19. Setting VoIP module Syslog will cause system crash. 20. VigorIPPBX did not end call when party hangs up in some situations 21.Recycle park slot number when the caller hangs up before the call transferred to the park server. 22. Extended silence time to avoid DTMF redial echo sound. 23. Fixed issue where FXS port could not send out FAX via SIP trunk. 24. Tone error detected under Virtual FAX Digit Map offnet call. 25. Fixed VigorIPPBX instability caused by SIP 180 messages with SDP contents. 26. Fixed issue where user cannot dial to ANY_ISDN via Digit Map. 27. Fixed issue where SIP video call causes VigorIPPBX to put the call on hold [Known Issue] 1. SIP trunk and extension configuration backup are not compatible with IE6.0. Please use Firefox for this feature. 2. If ISDN trunk has existed incoming call and outgoing call at the same time, out-going call would not be disconnected when time budget exceeded until incoming call disconnected. 3. Interoperability issues with VFax receiving a fax from SIP via T.38 - still under investigation 4. Use the version after V2154 for VigorTalk ATA24, otherwise it may occur continuous call transfer job and result in VigorIPPBX reboot. 5. After upgrade the newest system prompts must be put onto the system. Please see the system prompt file in the downloads section [Notes] 1. Please use the firmware upgrade utility to backup/restore V3510_xxx.cfg and VoipModule config. 2. Please upload the newest System Prompt after upgrading Vigor IPPBX firmware V3.5.7 . The voice prompt utility can be used for this purpose. ************************************************************************************ Release Notes for VigorIPPBX 3510 Firmware Version : 3.5.6 (Release Version) VoIP Module : 2.6.5 Release Date : 15th Dec 2011 Build Date : 6th Dec 2011 Applicable Models : VigorIPPBX 3510 Series Locale : UK Only ************************************************************************************ Important: If upgrading from earlier than 3.5.6 ensure that the newer (v2) IVR is also uploaded. Please use the IPPBX voice prompt utility (v1.1.0) NOTE : Disabling remote registrations is recommended if remote registrations are not required. This is controlled via [IP PBX]> [PBX System] > [SIP Proxy Setting] and also each extensions profile. NOTE : It is strongly recommended that you always use strong passwords for both the router/pbx itself and extensions to reduce the possibility of unauthorised access/calls. NOTE : After upgrade, check that VoIP Module has successfully upgraded. The module status will be listed in System Maintence. If the VoIP Module has not upgraded then factory reset the unit from the front panel and then upgade again. [New Features] 1. Support individual VoiceMail greetings which can be recorded via IP phones. 2. Support remote access for voice mail. 3. Support T.38 on FXS port. 4. Support Virtual Fax function. 5. Support quick switch between office and non-office IVR by pressing the service number from your IP Phone. (Turn ON/OFF Night Service on IP PBX>>PBX System>>PBX Service Number). 6. Support DDI/hunt group labeling on caller ID. 7. Support trunk line budget control. 8. Support extension block mechanism for consecutive registration with wrong password. 9. Support BLF status for hunt group [Improvement] 1. Fixed: Interoperability issue. When ITSP uses early-media to send ring back tone, it may cause no audio 2. Fixed: Extension answer mode for call forwarding issue. 3. Fixed: Call pickup function does not work if calls from PSTN trunk. 4. Fixed: No dial tone for ISDN-TE virtual channel. 5. Fixed: A user cannot hear ringback tone when incoming calls from PSTN/ISDN trunk. 6. Fixed: WAN privilege check issue for forwarding call. 7. Fixed: PSTN trunk may have no AA voice in some cases. 8. Fixed: If the AA prompt of system IVR is too short, VigorIPPBX will play it more than three times. 9. Fixed: SIP trunk DDI call cannot be correctly disconnected if the call matches call barring rules. 10. Fixed: Dialing an unregistered extension number would cause BLF state error. 11. Fixed: Improvments to call transfer operation via FXS 12. Fixed: Semi-attended call transfer does not work if referring to a group member but not a group number. 13. Fixed: Voice mail greeting message can not play due to CODEC error issue. 14. Fixed: Quick cancel for call to hunt group number may not work. 15. Fixed: One-way audio issue if enabling DMZ. 16. Fixed: Call pickup function does not work if calls from PSTN trunk. 17. Fixed: Interoperability issue with IP Phones that respond with 480 to indicate busy. 18. Improved: Add the timer to prevent IVR convert task block Web. 19. Improved: Add protection mechanism for DSP channel to avoid IVR codec conversion when VigorIPPBX uses the same channel to detect DTMF. 20. Improved: Add FXO dial tone detection option on WUI. 21. Improved: Potential call drop issue. 22. Improved: Support MoH on Park Server. 23. Improved: Add initial value for park slot number. 24. Improved: Add system prompt status in telnet. 25. Improved: Add extension status support block state. [Known Issue] 1. SIP trunk and extension configuration backup are not compatible with IE6.0. Please use Firefox to use the feature. 2. If ISDN trunk has existed incoming call and outgoing call at the same time, out-going call would not be disconnected when time budget exceeded until incoming call disconnected. ************************************************************************************ Release Notes for VigorIPPBX 3510 Firmware Version : 3.5.5.2 (Release Version) Release Date : 23rd May 2011 Build Date : 6th May 2011 Applicable Models : VigorIPPBX 3510 Series Locale : UK Only ************************************************************************************ [New Features] 1. Remote extension Access Control List in IPPBX>>PBX System>>SIP Proxy Setting (white list for WAN IP). 2. Modified the mechanism for answering inbound calls. For inbound calls into a hunt group or extension the VigorIPPBX responds with '180 Ringing' until the extension answers instead of immediately replying with '200 OK' 3. Add CDR log to Syslog with “csv” format. 4. Added Default Trunk option for each extension. Define the Default Trunk route via digitmap 5. Remote registration permissions can be controlled on a by extension basis. [Improvement] 1. Fixed: VPN function stability under certain conditions. 2. Fixed: ISDN may not hangup call. 3. Fixed: Off-Net call transfer from ISDN-TE to ISDN-TE cannot work. 4. Fixed: ISDN-S0 cannot pick up calls from PSTN trunk. 5. Fixed: PSTN port cannot use trunk line. 6. Fixed: SIP trunk cannot register a number with character "+". 7. Fixed: SIP trunk codec negotiation issue. 8. Fixed: Call pickup function does not work if the extension is not permitted to access the trunk line. 9. Fixed: Call pickup function wouldn't work if phone had been ringing for more than 32 seconds. 10. Fixed: Extension cannot pick up call with anonymous CLI. 11. Fixed: hunt group call will be hangup by PBX if more than 2 group members answer the call simultaneously. 12. Fixed: Hunt group overflow rule does not work if all group members are off-line. 13. Fixed: Aastra phone does not accept our call transfer NOTIFY. 14. Fixed: Aastra phone does not accept BLF update. 15. Fixed: Three WAN extensions leaving voice message to the same LAN extension simultaneously will cause crash. 16. Fixed: semi-attended call transfer to VMPBX do not work issue. 17. Fixed: In some circumstances an incoming call to the Auto-attendant could cause instability 18. Improved: Web UI improvement. 19. Improved: Enhance the trunk line usage security. 20. Improved: "Mail From field" added to Voicemail to email setup 21. Improved: Adjust greeting prompt timer from “fixed” to “dynamic”. 22. Improved: Newer VoIP Module firmware ************************************************************************************ Release Notes for VigorIPPBX 3510 Firmware Version : 3.5.5.1 (First Firmware Release) Release Date : March 17th 2011 Build Date : February 18th 2011 Applicable Models : VigorIPPBX 3510 Locale : UK Only ************************************************************************************ [END OF FILE]