Assuming router is required, the following results were found.

  • Update VigorAPs configuration by AP Management (APM)

    This article describes how to update the configuration of VigorAP using the Vigor Router's Central AP Management (APM) feature. With APM, you can create a WLAN profile for the wireless settings on the router and push the configuration to multiple...

    https://www.draytek.co.uk/support/guides/kb-apm-configuration
  • Using the Vigor 166 as an ADSL modem

    along with streaming services. Connecting ADSL with the Vigor 166 requires some reconfiguration, in that it needs to use Router Mode and PPPoE Pass-Through to convert PPPoE connections from your router or firewall, to the PPPoA (PPP over ATM) used by...

    https://www.draytek.co.uk/support/guides/kb-vigor166-adsl
  • FTP, PPTP and IPsec VPN PassThrough on DrayTek Routers

    DrayTek Vigor routers have a number of built-in services such as IPsec, PPTP and FTP servers that are operated internally by the router. When using other LAN servers on your network to provide these services, the router's in-built services must be...

    https://www.draytek.co.uk/support/guides/kb-vigor-passthrough
  • Introduction to DrayTek VPN Overview

    as it was) was to enable computer systems, at different locations around the world, to communicate with each other. Routers could determine how to reach the remote destination via multiple routers and intermediate networks. This provided both cost...

    https://www.draytek.co.uk/information/solutions/vpn-overview
  • DOCSIS (Cable Internet) - What is it and how does it work?

    'triple play' services - phone, TV and Internet access down a single coax cable. In the home, that cable will go to a modem/router (for Internet access) and to set-top boxes at each of your TVs for TV viewing. If you have also subscribed to telephone...

    https://www.draytek.co.uk/information/blog/docsis-cable-internet-what-is-it
  • How to reset the Vigor 3900 / 2960 to Factory Default settings

    The DrayTek Vigor 3900, 2960 and 300B routers differ from other DrayTek routers in the process of factory resetting the units - when one of these routers is factory reset, it clears its internal filesystem and reflashes the router firmware. Because of...

    https://www.draytek.co.uk/support/guides/kb-3900-factoryreset
  • Bandwidth Management - Session & Bandwidth Limitation

    identified by their IP address. For this reason, it is important to either separate groups of IP addresses using the router's multi subnet and VLAN facilities or by ensuring that the PCs always have the same IP address so that the correct limitations...

    https://www.draytek.co.uk/support/guides/kb-bandwidth-management-v3
  • Securing LAN ports on DrayTek Routers using 802.1X and User Management

    DrayTek routers that support Wired 802.1x can be configured to enforce RADIUS authentication before a device connected to the router's LAN port can communicate with the router and its connected network(s). This can be useful if the router is installed...

    https://www.draytek.co.uk/support/guides/kb-wired-8021x-internalradius
  • Teleworker VPN - L2TP over IPsec - Apple Mac OS X

    The DrayTek routers that support Dial-In VPN connections can use any compatible VPN client to connect a remote dial-in user VPN to achieve secured access to the network connected to the router and its internet connection. In this setup guide, the Apple...

    https://www.draytek.co.uk/support/guides/kb-teleworker-smartvpn-l2tpoveripsec-macos
  • Quality of Service Configuration & Setup Examples

    The Quality of Service system available on DrayTek routers allows for full control of how traffic is prioritised and bandwidth is reserved, with five queues available. The router assigns sessions to each one of these queues and schedules packets to be...

    https://www.draytek.co.uk/support/guides/quality-of-service-setup-examples
  • How do I make a local server accessible from the Internet?

    When running NAT (Network Address Translation) the Vigor router takes the single public IP address, allocated by your ISP and automatically passes data between it and the local PCs on your private local network. However, with only one address visible...

    https://www.draytek.co.uk/support/guides/kb-vigor-portforwarding
  • Start using Central AP Management

    This article shows how easy it is to start using Central AP Management (APM) on the router, with both DrayOS (e.g. Vigor 2865) and Linux (e.g. Vigor 3900) Vigor routers. Central AP Management (APM) is a management feature of DrayTek SMB routers. It...

    https://www.draytek.co.uk/support/guides/kb-central-ap-mngt
  • Vigor 2760 Series

    ADSL, ADSL2+ & VDSL2 Router Firewall Supports both ADSL2+ & VDSL2 BT SIN498 MCT Approved Ethernet WAN (for cable modems etc.) 3G/4G USB Modem Support as primary or backup/failure Native IPv4 & IPv6 dual-stack support IPv6 is the new protocol for the...

    https://www.draytek.co.uk/products/soho/vigor-2760
  • How do I enable Multiple LAN Subnets or set up VLANs?

    How do I set up VLANs / Multiple Subnets on a DrayTek Vigor Router? Configuring multiple LAN Subnet interfaces on a DrayTek Vigor router requires enabling VLANs (Virtual LAN interfaces) before the additional LAN Subnets can be enabled and utilised. An...

    https://www.draytek.co.uk/support/guides/kb-vigor-8021qvlan
  • Fitting a SIM card into the Vigor LTE router

    The DrayTek Vigor 2860Ln router's SIM card slot is located on the back of the router and is secured with a SIM card cover plate that screws into place. This slot requires a standard size SIM card; Nano or Micro SIMs will require an adapter (not...

    https://www.draytek.co.uk/support/guides/kb-fittingasimcard
  • Load Balancing Routers

    What is a load balancing router? A load balancing router is a router which can use more than one Internet connection simultaneously to provide internet access to devices connected to it. One of the benefits of load balancing is that it allows a network...

    https://www.draytek.co.uk/products/routers/load-balancing-routers
  • DrayTek Router WAN Performance and Hardware Acceleration

    of broadband packages where the speed is 300Mbps or higher - there is a demand to increase WAN performance from the router. DrayTek latest range of routers and firewalls incorporate greater performance capabilities to help you fully utilise Internet...

    https://www.draytek.co.uk/our-solutions/videos/draytek-webinars/draytek-router-wan-performance-and-hardware-acceleration
  • Port Forwarding

    server accessible from the Internet ? When connecting to the Internet with NAT (Network Address Translation), the Vigor router takes a single public IP address, allocated by your ISP and automatically passes data between it and the local PCs on your...

    https://www.draytek.co.uk/support/guides/kb-port-forwarding
  • VigorACS

    Platform VigorACS 2 is the latest version of DrayTek's Central Management System (CMS). It supports all current DrayTek routers and firewalls, providing System Integrators or system administration personnel a real-time integrated monitoring,...

    https://www.draytek.co.uk/information/vigoracs2
  • Vigor 3900 VPN Trunk to Vigor 2862 (DrayOS)

    3900 and Vigor 2862 have different interfaces for configuring the VPN trunk but this is fully interoperable between the two router types, this guide covers the setup of these two types of router to make a working VPN trunk between the two. Site A -...

    https://www.draytek.co.uk/support/guides/kb-3900vpn-trunk-to-drayos

Results 181 - 200 of 596