Using a Hitron (on VM service) in modem only mode but it's on a different subnet from the 2865 LAN1 so been trying to find a config to be able to access its admin page. Normal LAN1 subnet is 192.168.15.0/24, and Hitron admin page is 192.168.0.1. Looking for simple way to do this with NAT/static routing - is it possible?

Are you able to access the Hitron Web UI if you plug your PC straight into the modem (without the Draytek)? You may need to set a static IP on your PC.

If so, are you able to define static routes on the Hitron?

Hi ulysses888,

Are you sure the Hitron’s access page is at 192.168.0.1? When in Modem Mode, they normally get a default static IP of 192.168.100.1 or something similar to that, but not 192.168.0.1.


All of your subnets should be able to reach that admin page too, as it is on their route to the internet…

Yes I can but wanted a permanent solution

192.168.0.1 is the admin page address by default (i.e. in modem mode)

Just to confirm how your modem mode setup is working, do you have a public IP on the WAN interface of your Draytek?