Loopback Configuration in Vigor 2962 and 3910

Hello everyone,<br/>
<br/>
We are very new to DrayTek products and would like to know how to configure a loopback IP both by GUI and CLI. We've searched everywhere.<br/>
Your help will be much appreciated.<br/>
Thanks.

NAT loopback is enabled by default on Draytek routers, I don't know if it can be turned off.

Thank you. We would like to configure that with our own static IP address.

Maybe you mean like the loopback feature on the 2865?<br/>

<QUOTE>

Loopback Interface<br/>
Enable Loopback Interface ?<br/>
Note:<br/>
1. Management from WAN only available using Loopback IP, the WAN IP will not respond.<br/>
2. Source IP used for TR069,NTP,RADIUS/TACACS+,SYSLOG,SNMP.

</QUOTE>

That might need to be implemented as a new feature on the 3910/2962